MicroBlaster II Systainer Fit Out

Every tool has a job. This fit out makes sure the tool is always ready to do it.

This is a custom fit out for the MicroBlaster II by Ezebreak — a compact but serious landscaping and demolition tool. Everything it needs, organized exactly the way you use it.

Built inside a repurposed MIDI-Systainer T-Loc III (the modern equivalent is the Systainer³ L 237), the fit out uses 2 layers of 57mm Kaizen foam plus the original MIDI plastic tray — stacked into 3 layers that follow the natural workflow of the tool from setup to operation to wrap-up:

• 1st layer (top) — Hole boring and prep
• 2nd layer (middle) — Charges and MB II Head
• 3rd layer (bottom) — Maintenance tools and supplies
• Below the foam — Owner’s manual, out of the way but always there

The Tanos Adapt L clips on the front hold the hand pump used to activate the tool — right where you need it, right when you need it.

Systainer USA — One system. For everything. For everyone.

This post may contain affiliate links to products from Systainer USA and other vendors. We may earn a commission on qualifying purchases.