Another custom enhancement! This one attaches to the SYS-RB and holds panels, making them much easier to transport. Again, a V1 design - this uses layered (glued together with Weld-On 4), laser cut 1/4” acrylic, some plywood, and a nifty combination of hardware (from Elliott’s Hardware - one of the best stores on the planet)…
The acrylic slides into the back handle, while the four hardware prongs slide into the strap holes - Systainers then stack like normal on the SYS-RB, with the bottom systainer pushing right up against the thin piece of plywood on the bottom, right over the top of the edge of the acrylic insert…
And viola, 1.5” of panel storage, for all our wood and acrylic needs.
Check out the full selection of Systainers at Systainer USA.
This post may contain affiliate links to products from Systainer USA and other vendors. We may earn a commission on qualifying purchases.